Wiring circuit

Browse » home » circuit » fading » leds » Fading LEDs Circuit

---

Fading LEDs Circuit

The following diagram is the schematic diagram of fading LEDs schema. This kind of schema runs two LED strips in pulsing mode, i.e. one LED strip goes from off state, lights up gradually, then dims little by little, and so on. while one other LED strip does the contrary.



Components part:

R1, R2 = 4K7 R3 = 22K R4 = 1M * R5 = 2M2 * R6, R10, R11, R14, R15 = 10K R7, R8 = 47K Trimpot * R9, R13 = 27K R12, R16 = 56R

C1 = 1µF C2 = 100µF/25V D1-D4 etc = 5 or 3mm LEDs * IC1 = LM358 Q1, Q2 ,Q4 = BC327 Q3, Q5, Q6 = BC337 SW1 = SPST miniature Slider Switch B1 = 9V PP3 Battery

Circuit Works:

The IC1 contains two Op-Amps schema which will be used to generate triangular wave form.. The rising and falling voltage obtained at pin #7 of IC1 drives two complementary diagram formed by a 10mA continual current source (Q1, Q2 and Q5, Q6) and driver transistor (Q3 and Q6).
R4, R5 & C1 are the timing components: the total period can be varied changing their values. R7 & R8 vary the LEDs brightness.

Fading LEDs Circuit Notes:

• For those whishing to avoid the use of trimmers, suggested values for 9V supply are: R4=3M9, R9 & R13=47K and trimmers replaced by a short.
• Whishing to use a wall-plug adapter instead of a 9V battery, you can supply the schema at 12V, allowing the use of up to 6 LEDs per strip, or at 15V, allowing the use of up to 7 LEDs per strip.
• In this case, the value of the trimmers R7 & R8 should be changed to 100K.

Fading LEDs Circuit Source: RedCircuits